I finally figured out what I was screwing up, I didn't wire the proximity resistor, on pin 5. The fancy J1772 cord I purchased already wired into the nozzle.
I hooked it up, the Leaf honked (connected), I turned on the power hit the Leaf Timer override and it charged and without smoke. I left it in for about 2 minutes, shut it down, disconnected and felt for heat, there was none.
This version is on a PCB I made and it has a built in nrf24l01+ 2.4ghz transceiver, so I can add remote control. I'm going to use it to feed a website on a RaspberryPi and set charge timers and requested amps rate.
No comments:
Post a Comment